Wire missing / outside working area (E1)
Where to look: Charging base LED and boundary wire clamps.
Landroid reports Wire missing / Outside working area — it cannot find a valid boundary signal. Vision models may use camera navigation; confirm whether your unit uses a physical boundary wire.
Picture
Quick answers
What is wrong?
Landroid reports Wire missing / Outside working area — it cannot find a valid boundary signal. Vision models may use camera navigation; confirm whether your unit uses a physical boundary wire.
What you might notice
- Wire missing! Press START
- Outside working area
- Red LED on charging base
Can I fix this myself?
Usually yes for cleaning/checking. Difficulty: medium · about 20-60 min. If unsafe or unresolved, use mail-in repair / authorised service.
What you need
- Spare boundary wire for test loop
- Wire strippers
Do this
- If the mower is outside the territory: power off, move it inside, power on, press START.
- Confirm charging-base LED is solid green. If off: check outlet, charger, and cable. If red: reseat boundary wire in clamps; reverse AL/AR ends if clamped incorrectly.
- If LED flashes green: confirm clamps and inspect for a cut wire.
- Optional test: make a ~3 m (10 ft) temporary loop into the base clamps; if the error clears inside the test loop, repair the installed boundary wire.
- If unresolved, contact Worx support / request repair.
Parts (only if cleaning fails)
- Boundary wire
- Waterproof connectors
Official references
- https://www.worx.com/landroid-support
- https://www.worx.com/media/wysiwyg/pdp-pages/manuals/WR150M.pdf
- https://b2b.mybuildingsupplies.ie/media/uploads/2023/03/User-Manual_WR130E.pdf
- https://wiki.worx.com/en/Landroid-Classic-Maintenance/Test-the-boundary-wire-with-a-test-loop
- https://support-na.worx.com/en/WR150/Landroid-runs-outside-the-boundary-wire-a4be